Bond It Glue Mix 2 Part Epoxy Adhesive - 2x 14g

The working time is typically short, often around 5 minutes, depending on the temperature. It's important to mix only what you can use within this timeframe.

Full cure is usually achieved within a few hours, but handling strength is often reached in minutes. Refer to the product packaging for specific times as they can vary.

While it creates a strong bond, it is a rigid epoxy. It is best suited for rigid materials and may crack if the bonded item is subjected to significant flexing.

Store in a cool, dry place, away from direct sunlight, with the caps tightly sealed. Ensure the original packaging is intact.

Once fully cured, the Bond It Glue Mix provides a water-resistant bond, suitable for many applications exposed to moisture, though prolonged immersion may degrade the bond over time.

The shelf life is typically 1-2 years when stored correctly. Check the packaging for an expiry date. Ensure both components are used before this date for optimal performance.

Yes, once fully cured, the bonded area can often be sanded to smooth the join and can be painted over with most types of paint.

Ensure equal parts of resin and hardener were used and mixed thoroughly. Check for proper storage conditions and ensure the product is within its shelf life. Environmental temperature may also affect cure speed.

Verify that surfaces were properly prepared (clean, dry, free of contaminants). Ensure adequate mixing and correct application time. The bond may not have been fully cured before stress was applied.

Gently squeeze tubes to avoid excessive pressure. If one component is significantly harder to dispense, it might be partially blocked or nearing the end of its usability.

Ensure the product is stored at room temperature before mixing, as cold can increase viscosity. Mix thoroughly; sometimes this action can help. If very cold, allow tubes to warm up slightly.