Blackbird Retro Graphics Kit For KTM SX125 2023 - Pink/Purple/White

The kit includes graphics for radiator shrouds, airbox, fork protections, swing arm, front fender, rear fender, and Motocross/Enduro plates.

The graphics use a 0.5mm thick crystal layer combined with a strong sticker specifically designed for off-road use.

You must thoroughly clean all plastic surfaces where the graphics will be applied, ensuring they are free from dirt, grease, and wax.

No, the instructions explicitly state not to use soaps or solvents during installation. Heat and pressure are the recommended methods.

Clean the graphics with a soft, damp cloth. Avoid abrasive cleaners or directing high-pressure washing directly at the graphics.

This specific kit is designed for the KTM SX125 2023. Compatibility with other models or years is not guaranteed.

To obtain the best results, the sticker must always be warmed up with a dryer and exposed to light pressure during application.

Gently lift the edge of the bubble, re-warm the area slightly with a dryer, and reapply with firm pressure, working outwards to push air out. For small bubbles, a pinprick can release trapped air.

Ensure the plastic surface was thoroughly cleaned and dried before application. Re-warm the graphic and apply firm pressure, especially on edges and curves. Check that no soaps or solvents were used.

Apply heat more gradually and evenly. Use lighter pressure on highly curved or complex areas, allowing the material to stretch slightly rather than forcing it. It may be necessary to trim excess material carefully.

Ensure the graphics are not exposed to excessive direct sunlight for prolonged periods when not in use. Clean gently with a damp cloth rather than harsh chemicals.