MODROC PLASTER OF PARIS MODELLING CRAFT BANDAGE - 15cm x 20 Metre

Use warm water. The MODROC bandage needs to be soaked for just a few seconds until fully saturated.

Drying time depends on the thickness and environmental conditions. Allow several hours to dry. Thicker applications may take up to 24 hours.

Yes, you can paint MODROC once it is completely dry. Acrylic paints work well.

Use water to lightly smooth the surface while the MODROC is wet. This can be done with your fingers or a modeling tool.

No, once the MODROC has dried, it cannot be softened and reused.

Dispose of dry MODROC in the regular trash. Wet plaster should not be poured down the drain.

You will need water, a container to soak the bandages, scissors, and a surface to protect your working area.

Ensure the surface is clean and slightly roughened. Make sure the MODROC is properly soaked and applied with some overlap.

Soak the MODROC in warm water for a few seconds to soften it, or use a tool such as a sculpting knife.

Ensure that the area is well-ventilated. In humid conditions, it might take longer to dry.

Apply MODROC in thin layers and allow each layer to dry before adding the next one. Use water to smooth the surface when applying.