Loops Wire Brush - 100mm

This brush is ideal for cleaning and preparing metal surfaces, removing rust, scale, paint, and other tough contaminants. It can also be used on concrete and other robust materials.

This brush has a 6mm shaft and is compatible with most drills and rotary tools that accept this shank size. Always verify your tool's chuck capacity.

The maximum recommended speed for this wire brush is 4500 RPM.

Clean debris after use, store in a dry place to prevent rust, and inspect for wear. Replace when filaments are bent, broken, or performance is reduced.

No, due to its aggressive stainless steel filaments, it is best suited for robust materials and may be too abrasive for delicate surfaces. Always test on an inconspicuous area first.

Always wear safety glasses or goggles to protect your eyes from flying debris. Gloves are also recommended to protect your hands.

Ensure the brush shaft is inserted fully and the chuck is tightened securely. Check for any damage to the shaft or chuck.

Filaments may be worn or clogged with debris. Clean the brush thoroughly. If filaments are significantly worn or bent, it's time to replace the brush.

This can be due to an unbalanced brush (due to wear or damage) or improper mounting. Ensure the brush is securely and evenly seated in the chuck. If vibration persists, replace the brush.

You may be applying too much pressure or using the brush on an inappropriate surface. Reduce pressure and ensure it's suitable for the material. Inspect for damage and replace if necessary.