Jarder Iron Sulphate - 2.5kg X 4

Application frequency depends on lawn needs and conditions, but generally, it can be applied every 4-6 weeks during the growing season. Always refer to the product label for specific recommendations.

No, Jarder Iron Sulphate is formulated for natural grass lawns and is not intended for use on artificial turf.

While the product is applied to the lawn, it is recommended to keep pets and children off the treated area until it has been watered in and dried to prevent accidental ingestion or contact.

The best time to apply is during the active growing season, typically spring through early autumn, when grass can readily absorb the nutrients. Avoid application in extreme heat, drought, or when frost is imminent.

One 2.5kg bucket of Jarder Iron Sulphate can cover up to 2500 square meters.

The 'X 4' indicates that the product comes as a pack of four 2.5kg buckets, totaling 10kg.

Iron Sulphate can significantly alter water chemistry, leading to harm or death of fish and other aquatic organisms. It must not be allowed to enter drains, sewers, or waterways.

Ensure the correct dilution rate was used and the product was applied evenly. Check if weather conditions (e.g., drought, extreme cold) are hindering nutrient uptake. Reapplication may be necessary after 10-14 days if results are not apparent, following recommended guidelines.

Immediately sweep or rinse any product that has fallen on hard surfaces before it dries. If staining has occurred, it may be permanent. Always use a shield or apply carefully to avoid contact with non-grass areas.

Ensure you are using the correct amount of water for mixing and stirring vigorously. Allow some time for the powder to fully hydrate and dissolve. If issues persist, try mixing in smaller batches.

This could indicate over-application or application during unfavorable conditions. Ensure you have followed the dilution and application rate instructions precisely. Water the lawn thoroughly to dilute any excess product in the soil.