Flat Metal File - 200mm - Medium Cut - T12 Steel - 8"

This file is primarily used for shaping, deburring, and finishing metal surfaces and hard synthetic materials. Its flat profile is ideal for working on planar areas and edges.

This refers to the density and spacing of the file's teeth. A medium cut provides a balance between removing material efficiently and leaving a relatively smooth finish, suitable for general-purpose work.

The file is manufactured from high-carbon T12 tool steel, known for its hardness and wear resistance, ensuring durability and a long service life.

While not strictly required for all tasks, using a file handle is highly recommended for safety, control, and comfort, especially during extended use. It protects your hand from the file's tang.

Clean the file after each use with a file card or stiff brush, moving in the direction of the teeth. Store it in a dry place, ideally with a protective sleeve, to prevent rust and damage.

Yes, it can be used on dense wood, but it's primarily designed for metal and hard synthetics. For extensive wood shaping, specialized wood rasps or files are generally more effective and less prone to clogging.

The file is 200mm (approximately 8 inches) in length, excluding the tang.

Ensure the file is clean and free of debris. Check if the teeth are worn down. Try brushing the file with a file card. If worn, replacement may be necessary.

This can happen with softer materials. Clean the file thoroughly with a file card. Consider using a file with a coarser cut or a different tool for very soft or gummy materials.

Store the file in a dry environment. If rust is present, gently scrub with a fine steel wool or a rust remover, then dry thoroughly. Apply a light coat of oil for protection if storing for an extended period.

Avoid dropping the file or striking it against hard surfaces. Inspect for chipping or bending. Damaged teeth will impair performance and may need the file to be replaced.