Tap and Die Set - 20 Pieces - Metric M3-M12

The set includes metric taps and dies ranging from M3 x 0.5mm to M12 x 1.75mm.

This set is suitable for working with aluminum, brass, carbon alloy steel, cast iron, and bronze.

Yes, the set comes complete with a tap wrench and a die holder for convenience and control.

No, this is a metric set and is designed specifically for metric thread sizes.

After use, clean the tools thoroughly, dry them, and apply a light oil before storing them in the case in a dry place. Always use cutting fluid during operation.

The hardened tungsten alloy steel provides high strength, durability, and resistance to corrosion and wear, ensuring the tools last longer and maintain their cutting edge.

Ensure you are using sufficient cutting fluid. Check that the tap/die is properly aligned and perpendicular to the material. Verify you are using the correct size and pitch for the material.

This can happen if too much force is applied or if the tap binds. Try to back the tap out carefully. If broken, specialized extraction tools may be needed.

Apply more cutting fluid. Ensure the die is cutting on the end of the material and not binding. Clean any accumulated chips from the die and workpiece.

Ensure tools are cleaned and dried thoroughly after each use. Apply a light coat of oil before storing them in the case. Store in a dry environment.