Taps2Traps Waste Pipe Blanking Plug Cap - 36mm
Best current price£6.99from B&Q
Best offers
Shopping.co.uk recommended and popular offers
B&Q£6.99Visit shop B&Q - Waste Pipe Blanking Plug Cap Fits 36mm Pipe ( 1.25" Bsp Waste) W32K
Visit shopB&Q£6.99Visit shop One Offer
1 offer from £6.99
View price history by clicking the chart icon.
B&QB&Q - Waste Pipe Blanking Plug Cap Fits 36mm Pipe ( 1.25" Bsp Waste) W32K
Free delivery in 1–3 days
£6.99
Visit shop
Product Information
Full details
The Taps2Traps 36mm Waste Pipe Blanking Plug Cap is an essential component for DIYers and professional plumbers looking to securely seal off 36mm (1.25 inch BSP) pipe ends. It provides a reliable, watertight solution for closing off plain pipework during renovations or appliance removals, though it is important to note that it is designed exclusively for push-fit application on plain ends rather than threading onto existing connections.
All features
| Model Part Number | W32K |
|---|---|
| Brand | Taps2Traps |
Extended Product Information
FAQs
Can I screw this cap onto a threaded pipe end?
No, this product is designed strictly for push-fit application onto plain pipe ends and will not fit onto threaded connections.
Is this cap reusable?
While it can be removed, the compression seal may lose effectiveness over time; it is generally recommended to replace it if it has been under pressure for a long period.
Will this work on metal pipes?
Yes, this cap is compatible with copper and lead pipes, provided the outer diameter matches the 36mm (1.25 inch) specification.
Does this cap require glue or silicone?
The product is designed to provide a watertight seal via its compression fit. No adhesive or silicone is typically required, though surfaces should be clean.
Can I use this for high-pressure water lines?
No, this component is intended for waste pipe systems, which operate under low or gravity-fed pressure. Do not use on pressurized water mains.
Troubleshooting
Cap does not fit snugly
Verify the pipe diameter is exactly 36mm (1.25 inch) and ensure there is no old adhesive or burrs on the pipe edge preventing the cap from seating.
Minor moisture weeping at the seal
Remove the cap, clean the pipe surface thoroughly with a cloth, and re-apply firmly to ensure a consistent compression fit.
Pros and Cons
Pros
- Simple, tool-free push-fit installation
- Provides a secure, reliable watertight seal
- Compatible with plastic, copper, and lead pipe materials
- Ideal for quick sealing of abandoned pipe ends
Cons
- Not suitable for threaded connections
- Limited to 36mm (1.25 inch) pipe sizes
- Cannot be used as a replacement for screw-on end caps
Setup, Compatibility & Care
To install, ensure the pipe end is clean, dry, and free of debris or jagged edges to allow the seal to seat correctly. Simply push the cap firmly onto the 1.25 inch (36mm) pipe end until it is fully seated. This component is compatible with rigid plastic, copper, and lead pipes. For care, periodically check the seal after initial installation to ensure no moisture is escaping. Avoid using aggressive chemical solvents on the exterior of the cap to maintain its structural integrity over time.