Dome Head Multigrip Rivets - 4.8 X 15mm - Beige

These multigrip rivets are designed for a grip range of 5mm to 10mm. This is the total thickness of all materials being joined.

You will need to drill a 4.9mm diameter hole for these 4.8mm diameter rivets.

Constructed from aluminium and steel, they offer good durability. For prolonged outdoor exposure, consider potential corrosion over time, although the materials used provide resistance.

While primarily designed for materials like roof sheets and plastic sheets, they can be used on wood if the combined thickness is within the 5mm to 10mm range and the hole size is appropriate. However, ensure the wood provides sufficient support.

Multigrip rivets have a wider grip range, allowing them to fasten materials of various thicknesses with a single rivet size. Standard rivets are designed for a more specific, narrower grip range.

They have a shear strength of 1500 N and a tensile strength of 2350 N, providing substantial holding power for many applications.

The dome head is a rounded head shape that provides a smooth, low-profile finish on the surface where the rivet is installed.

Ensure the rivet is fully seated in the rivet gun and the material thickness is within the 5mm-10mm grip range. Check that the rivet gun is functioning correctly.

Verify the material thickness aligns with the rivet's grip range. Ensure the correct size rivet is being used with the rivet gun.

Confirm the correct drill bit size (4.9mm) was used. If the hole is too large, the rivet may not form a tight joint. If too small, the rivet may not insert.

Check that the total material thickness is within the specified 5mm-10mm grip range. Re-riveting may be necessary if the initial setting was compromised.