Heable Monobloc Mixer Tap Connectors - 600mm Long - Silver

These connectors are constructed from high-quality grade 304 stainless steel, which is known for its durability and resistance to rust and corrosion.

Yes, they are made from lead-free materials, ensuring a safe and healthy water supply.

The connectors feature standard UK G1/2 fittings on one end and an M10 thread on the other, designed to connect to tap tails.

For a standard monobloc mixer tap, you will typically need two flexi pipe connectors: one for the hot water supply and one for the cold water supply.

These flexi pipes are not designed to be cut. Using them at their intended 600mm length ensures the integrity of the connection and material.

While designed for residential use, specific temperature and pressure ratings should be confirmed with the manufacturer if operating outside typical household conditions.

Ensure the M10 thread is properly seated and hand-tightened before final spanner tightening. Check if a rubber washer is present and undamaged inside the connector end.

Verify the G1/2 fitting is correctly aligned and hand-tightened before final spanner tightening. Ensure the rubber washer inside the connector is present and in good condition.

Check that the isolation valve is fully open. Inspect the connector for any kinks or internal blockages. Ensure no debris entered the pipe during installation.

Slight rattling can sometimes occur due to water flow. Ensure the connector is not touching any surrounding surfaces. Check if the tap itself is the source of the noise.