JG Speedfit Straight Connector 22mm - White Plastic

You will need a pipe cutter (for cutting pipes squarely), and potentially a deburring tool. No other special tools are required.

This fitting is designed for use with plastic and copper pipes. Always check the pipe specifications to ensure compatibility.

Yes, when using plastic pipes, you must use the correct manufacturer’s pipe insert. This is essential for a secure and leak-free connection.

Unlock the nut, push the collet towards the fitting body, and then pull the pipe to release it.

Yes, the fitting is reusable, provided it is in good condition and has not been damaged.

Check the manufacturer’s specifications for the specific pressure rating of the fitting.

Ensure the pipe is fully inserted, the nut is properly locked, and the correct pipe inserts are used with plastic pipes. Check for leaks after installation.

Refer to the JG Speedfit product documentation or contact their customer support for further assistance.

Ensure the pipe is fully inserted into the fitting. Check that the nut is properly locked. If the leak persists, replace the fitting.

Make sure the pipe ends are clean and free of burrs. Ensure you are using the correct pipe inserts for plastic pipes. Lubricate the pipe end with a small amount of silicone grease.

Ensure the nut is unlocked. Push the collet towards the fitting body while pulling the pipe.