Liberon Beeswax Paste - Clear - 150Ml

Ensure the wood is clean, dry, and free from dust, grease, or old finishes. Light sanding may be beneficial for a smoother finish. Wipe the surface clean before application.

Apply a thin, even coat using a soft cloth or fine steel wool (grade 000). Work the product into the wood following the direction of the grain.

The paste typically dries to the touch within approximately 6 hours. Allow adequate drying time before applying a second coat or using the furniture.

No, Liberon Beeswax Paste Clear is formulated for interior wood surfaces only and is not suitable for exterior use.

Tools used for applying the beeswax paste can be cleaned effectively using white spirit.

The clear beeswax paste is designed to enhance the natural color and grain of the wood without significantly altering its original tone. It adds a soft sheen and depth.

This product is best applied to bare or stripped wood. If applying over old finishes, ensure they are stable and compatible. For best results, it is recommended to remove old varnish or paint first.

This can occur if too much product is applied or if it is not buffed off sufficiently. Ensure a thin, even coat is applied and buff thoroughly with a clean cloth until a uniform sheen is achieved. For existing streaks, try buffing with a clean cloth or applying a very light additional coat and buffing immediately.

The wood may be very dry or have absorbed the initial coat quickly. Apply a second thin coat of beeswax paste and buff again. Ensure you are working the product into the grain and buffing off the excess effectively.

This usually indicates that an excessive amount of product was applied or not buffed off properly. Use white spirit on a clean cloth to gently wipe down the surface, removing the excess sticky residue. Buff with a clean, dry cloth until the surface is smooth.