Drybase Flex Adhesive - Grey

Drybase Flex Adhesive is used specifically for fixing Drybase Flex Membrane to walls, particularly suitable for damp or salt-contaminated surfaces.

It is designed for cementitious substrates and is particularly effective on damp and salt-contaminated walls. Ensure the surface is structurally sound and free from loose contaminants.

The wall is typically ready to accept plastering within 30 minutes of the Drybase Flex Membrane being adhered with the adhesive.

Yes, the product is supplied in powder form and must be mixed with clean water according to the manufacturer's instructions before application.

The product description focuses on internal wall applications, particularly for damp-proofing and moisture control internally. Consult the manufacturer for specific external use guidelines.

Refer to the product packaging for the specific shelf life and storage recommendations. Typically, cement-based products should be stored in a cool, dry place.

Yes, Drybase Flex Adhesive is compliant with EN 12004:2007.

Ensure you are using the correct ratio of water to powder as per the manufacturer's instructions. Adjust slightly if needed, but maintain the recommended proportions for best performance.

Check if the substrate was properly prepared (clean and free of dust). Ensure the adhesive was applied evenly and the membrane was pressed firmly into the wet adhesive before it started to set.

Ensure you are mixing only the amount of adhesive that can be used within its pot life. Work in smaller batches if needed, especially in warmer temperatures.

While the adhesive is designed for damp substrates, excessively saturated surfaces may require additional preparation or allow for some surface evaporation before application.