K2 Caliper Spray Paint - Yellow - 400ml

No, the product can be used for caliper painting with or without complete disassembly. However, thorough masking is essential if not fully disassembled.

The paint is dry to the touch in 30-60 minutes at 20°C. Full cure, meaning it reaches maximum hardness and durability, takes approximately 12 hours at 20°C.

You must not allow the product to coat friction elements, cables, and moving brake parts. These components are critical for safety and functionality.

This spray is specifically formulated for brake calipers due to its high-temperature resistance. It is not recommended for general automotive painting.

A 400ml can typically provides enough paint for 2-3 coats on all four brake calipers, depending on their size and the desired finish.

Clean the surface with 240-360 grade sandpaper, then degrease it thoroughly to ensure proper adhesion.

While it can be applied in cooler temperatures, the drying and curing times will be significantly longer. For best results, apply in temperatures around 20°C.

Apply thinner coats from a slightly greater distance. Ensure the can is shaken adequately before and during use. If runs occur, allow to dry and gently sand before reapplying.

The surface may not have been properly cleaned or degreased. Ensure all grease, dirt, and rust are removed before painting. Re-sanding and degreasing may be necessary.

Shake the can well. After use, turn the can upside down and spray for a few seconds to clear the nozzle. If still clogged, try a replacement nozzle if available or a new can.

Ensure the can was shaken thoroughly for the recommended time. Apply coats evenly. If the base color is dark, multiple coats might be needed for the yellow to appear vibrant.