Tile Levelling System - 100 X Twister Nuts & 200 X Twister Clips - White - TLS2/TLN1

The number of clips and nuts required depends on the size and layout of your tiles. As a general guide, use one clip per side of each tile.

No, the clips are designed for single use. The twister nuts are reusable.

Use a tile adhesive appropriate for your tile type and the surface you are tiling. Follow the adhesive manufacturer's instructions.

For large format tiles, consider using additional supports or a system designed for heavier tiles.

Wipe the twister nuts with a damp cloth after each use to remove any adhesive residue, ensuring they are ready for the next project.

Yes, this system is suitable for both wall and floor tile installations.

Allow the adhesive to fully cure, then kick or tap the clips in the direction of the grout lines.

Double-check that the clips are correctly positioned under the tiles and the nuts are tightened sufficiently. Ensure the subfloor is level. Make sure the clips aren't defective.

Wait until the adhesive is fully cured. Use a rubber mallet or your foot to kick the clips in the direction of the grout lines.

Avoid over-tightening the nuts. Replace any damaged nuts before continuing the installation. Ensure proper storage.

Ensure that the adhesive is not dried on the clips and follow the manufacturer's directions. Use a rubber mallet to remove the clips.