Self Adhesive Vinyl Floor Tiles - Pack of 10

Each pack contains 10 tiles.

One pack of 10 tiles covers approximately 10 square feet (0.9 square meters).

Each tile measures 12x12 inches (30.5 x 30.5 cm).

While the tiles are waterproof, they can become slippery when wet. It is recommended to use them in areas like bathrooms and kitchens but to ensure the surface is promptly dried. Avoid direct, prolonged exposure to shower spray if possible.

No, installation is designed to be simple. You only need basic tools like scissors or a utility knife if you need to trim the tiles.

Yes, you can install them over existing smooth, non-porous flooring like vinyl, linoleum, or sealed hardwood. Ensure the existing floor is clean and dry.

While designed for a strong bond, they can be carefully removed. However, removal may cause damage to the subfloor or leave adhesive residue, depending on the surface and how long they have been installed.

The tiles have a thickness of 1.5 mm.

Ensure the floor surface is thoroughly cleaned, dried, and free of any dust, grease, or old adhesive. Re-apply pressure to the tile. For best adhesion, wait 24-48 hours before exposing to heavy foot traffic or water.

Lift the tile immediately and re-apply, smoothing out any air pockets as you press it down. If bubbles persist, the surface may not be smooth enough, or air was trapped during application.

Gently lift the edge and re-apply pressure. Ensure the edges of adjacent tiles are firmly pressed together. Trim edges if necessary for a tighter fit.

Promptly dry any water or liquid spills on the floor surface. Consider using a non-slip rug or mat in high-moisture areas if this remains a concern.