Best current price£19.97from B&Q
Shopping.co.uk recommended and popular offers
B&Q£19.97Visit shop B&Q - Soft Sage Wood Matt 67.5Cm X 3M Self-Adhesive Vinyl Wrap For Doors And Worktops
Visit shop1 offer from £19.97
View price history by clicking the chart icon.
The D-C-Fix Soft Sage Wood Matt vinyl film is designed for DIY enthusiasts and renters looking to refresh worktops, kitchen doors, and furniture with an authentic woodgrain aesthetic without the cost of a full renovation. This German-engineered, phthalate-free wrap offers a durable, wipe-clean surface that is easy to apply and reposition; however, users should note that while it is heat-resistant up to 70ºC, it requires careful sealing around high-moisture areas like sinks.
| Model Part Number | 200-8251-3 |
|---|---|
| Brand | d-c-fix |
The film is heat-resistant up to 70ºC. It is safe for standard kitchen use, but you should not place boiling pots directly onto the vinyl.
Yes, it is moisture-resistant and wipe-clean, making it suitable for kitchens and bathrooms, provided you seal edges near sinks.
No, the adhesive is designed for easy removal. Warming it with a hairdryer will soften the glue, allowing you to peel it off without residue.
For the best results, use this on flat, smooth, and clean surfaces. Textured surfaces may prevent the adhesive from bonding correctly.
Measure the length and width of your target area and add 5-10cm to each dimension for trimming leeway.
Use a pin to prick the bubble gently and smooth the air out towards the hole with your felt tool.
Apply gentle heat with a hairdryer to soften the film, then pull it firmly around the corner and hold it in place until it cools.
Ensure the area is completely dry, clean with alcohol, and re-seal the edge with a high-quality waterproof silicone sealant.
To begin your project, you will need a sharp utility knife, a felt-edge smoother, and a measuring tape. Measure your surface area carefully and cut the film using the grid on the reverse, leaving a 2-3 cm overlap for trimming. Peel back a small section of the backing paper and smooth the vinyl onto the surface using the felt tool to remove air bubbles. Work in small sections, moving from the center outward. For maintenance, simply wipe the surface with a damp cloth and a mild soap solution. Avoid using abrasive sponges or harsh chemicals, as these may scratch the matte finish. If you need to remove the wrap in the future, heat the film evenly with a hairdryer to soften the adhesive before gently peeling it away from the surface.
