Blueprint Joinery Basic Angled Edge Moulding Cover Bead - Brown - Pack of 10

These angled beads are crafted from high-quality pine wood.

Each angled bead measures 27mm in width and 27mm in depth.

Yes, they have a planed finish that is easy to paint, oil, varnish, or stain to match your desired decor.

They are typically attached using wood adhesive and can be secured with pins or clamps until the adhesive sets.

These beads are designed for interior use. For outdoor applications, a suitable weather-resistant finish and appropriate treatment would be necessary, but they are not specifically designed for exterior environments.

Each pack contains 10 angled edge moulding cover beads.

They come with a planed finish, which is generally smooth and ready for finishing. Light sanding can be done if a perfectly smooth surface is desired before applying paint or varnish.

Check for obstructions on the wall corner or ensure the bead itself is not warped. Trim any excess adhesive or debris. Slight adjustments may be needed during installation.

Ensure the surface was properly prepared and free of dust before finishing. Apply thin, even coats and allow adequate drying time between applications. Sand lightly between coats if necessary.

Ensure the correct type of wood adhesive for your project is used and applied evenly. Check that the surfaces are clean and dry. Use temporary clamps or pins until the adhesive cures.

Pre-drill pilot holes slightly smaller than the nail diameter, especially near the ends of the bead. Use finer gauge nails or pins.