Kenable Faceplate - Cat6A Shielded FTP - 2 Port RJ45

No, this faceplate is designed to connect pre-terminated RJ45 Ethernet cables directly into the front and back, eliminating the need for manual wiring.

This is a Cat6A shielded faceplate, supporting network speeds up to 10 Gbps and bandwidth up to 500 MHz.

The faceplate dimensions are 85mm x 85mm. The RJ45 module size is 14.5mm x 33.5mm, with a depth requirement of 30mm from the faceplate to the end of the module.

It is recommended to use this faceplate where there is sufficient clearance behind the panel. If installing into a cavity wall or a shallow space, you may need to use an extension back box or a right-angled pre-made cable for the rear connection.

Yes, this is a shielded FTP (Foiled Twisted Pair) faceplate, designed to help reduce electromagnetic interference.

You can connect pre-terminated RJ45 Ethernet cables. It supports Cat5e, Cat6, Cat6a, and Cat7 standards.

Verify that both the front and rear RJ45 cables are securely plugged in and fully seated. Check that the cables themselves are not damaged and are correctly terminated (if applicable to the cable used).

Ensure you are using Cat6A rated cables for optimal performance. Check for any kinks or damage to the cables. Confirm that the connected network devices and your router/switch also support Cat6A speeds.

This unit requires significant rear clearance. If space is tight, consider using a right-angled RJ45 patch cable on the rear connection or install the faceplate with an appropriate extension back box.