Rikä 1/2" Breaker Bar - 610mm

Yes, the 1/2-inch drive is fully compatible with impact-rated sockets.

No, a breaker bar is designed for loosening fasteners. You should always use a calibrated torque wrench for tightening to ensure accurate specifications.

While the bar is built for high-torque applications, it is a manual tool. Avoid using cheater pipes or extensions on the handle, as this can exceed the design tolerances.

The length is designed to maximize mechanical advantage, allowing you to generate significantly more torque than a standard-length ratchet.

Please check with your specific retailer or the Rikä documentation provided in the packaging for warranty coverage details.

Ensure the spring-loaded ball detent on the square drive is not stuck; clean any debris out of the detent hole.

The pivot tension can often be adjusted via the center bolt on the head; tighten gently until the desired resistance is achieved.