External Brick Clamp - Spiked Sliding Clamp - Silver

The clamp is available in two main lengths: a large size of 550mm and a small size of 330mm.

This clamp is designed for use with profiles measuring 40mm, 50mm, or 50.8mm.

The spiked end is designed to be hammered into a mortar joint. Its effectiveness depends on the condition and type of mortar. It is best used in joints that are firm but not fully cured, allowing for secure insertion without compromising the joint.

The RHINOGRIP thumbscrew allows for easy and secure tightening of the clamp onto the profile, ensuring a firm grip without the need for additional tools.

After use, clean off any excess mortar or debris with a brush. Wipe the clamp dry and store it in a dry place to prevent rust and maintain the integrity of the zinc plating.

No, this clamp is specifically designed for external corners.

The clamp is constructed from zinc-plated steel for enhanced durability and corrosion resistance.

Ensure the RHINOGRIP thumbscrew is tightened sufficiently. Check that the profile is clean and free from obstructions. Verify that the profile size is compatible with the clamp's specifications.

Ensure the mortar joint is adequately prepared and not too wet or too dry. Apply steady, firm pressure when hammering the spike. Avoid excessive force that could damage the brickwork.

This is a natural process for metal parts exposed to elements, though zinc plating offers resistance. Clean the clamp thoroughly and ensure it is dried completely after each use. For severe corrosion, consider replacement to maintain performance.

Confirm both the profile is securely clamped and the spiked end (if used) is firmly anchored in the mortar. Ensure the clamp is correctly positioned for the external corner.