Best current price£7.08from B&Q
Shopping.co.uk recommended and popular offers
B&Q£7.08Visit shop B&Q - 1/4" Bsp Thread Hose Tail 3/8" (10mm) Pipe Connector Air Fitting Ft032
Visit shop2 offers from £7.08
View price history by clicking the chart icon.
The AB Tools-PCL FT032 hose tail is an essential component for professionals and DIY enthusiasts building or maintaining pneumatic air systems. This fitting excels at providing a secure, leak-free transition between a 1/4 inch BSP threaded port and a 3/8 inch (10mm) bore hose. While it offers robust construction in durable plated steel, users should be aware that the 1/4 inch BSP sizing refers to the industry standard thread specification rather than the physical outer diameter, which measures approximately 13mm.
| Model Part Number | FT032 |
|---|---|
| Brand | AB Tools-PCL |
No, 1/4 inch BSP is a nominal pipe standard. The actual outer diameter of the thread is approximately 13mm.
This fitting is designed for hoses with a 3/8 inch (10mm) internal bore.
While it is designed for pneumatic air systems, the plated steel construction is suitable for some low-pressure fluid applications, though air systems are its primary use case.
Yes, it is highly recommended to use PTFE tape on the BSP threaded end to ensure an airtight seal.
This fitting is designed for standard workshop and pneumatic pressures. Always ensure your hose and clamping method are rated for your specific pressure requirements.
Ensure sufficient PTFE tape was applied to the threads and check if the fitting is tightened securely.
Verify that you are using a 3/8 inch bore hose and ensure a hose clip is properly tightened over the tail section.
To install, first apply a small amount of PTFE tape to the male BSP thread to ensure a leak-proof seal against your tool or compressor outlet. Use a standard open-ended wrench to tighten the fitting; avoid using excessive force or pipe wrenches with sharp teeth, as these can damage the plating. Because BSP sizing is standardized but non-intuitive, always measure your threaded port or verify the equipment specifications before purchase to ensure the 13mm thread diameter matches your requirement. Regularly inspect the fitting for signs of wear or rust if the system is used in a high-moisture environment.
