McAlpine Bath Filler and Overflow - Chrome Plated Brass - 1m

The 1m braided hose provides significant flexibility during installation, allowing for easier routing and connection, especially beneficial for baths with curved designs or non-standard tap placements.

The water seal bath trap prevents unpleasant sewer gases from entering your bathroom by maintaining a water barrier within the trap.

This kit is compatible with bath overflow holes measuring between 46mm and 65mm in diameter.

The main filler and waste outlet are constructed from chrome-plated brass, ensuring durability and a high-quality finish.

Clean the chrome surfaces using a soft, damp cloth. Avoid abrasive cleaners or scouring pads to prevent scratching.

Flow rates are approximately 33 l/min at 0.5 bar, 44 l/min at 1 bar, and 57 l/min at 2 bar.

The kit includes the bath filler, overflow tube, bath trap, mushroom plug, and the 1m braided hose. Standard plumbing fittings and sealants may also be required depending on the specific installation.

Check that the water supply valve is fully open and ensure there are no kinks in the 1000mm braided hose. Verify water pressure meets the minimum requirement (0.5 bar).

Inspect the bath trap and overflow tube for any blockages from hair or debris. Clean the trap by removing it (if accessible) or using a drain clearing tool.

Ensure the spring-loaded mechanism is free of debris. Check if the plug or its seating is damaged; if so, replacement parts may be needed.

Ensure the connection is tightened securely. Check any seals or washers for damage and replace if necessary.